News

News

Company News

Industry Information

Introduction of mechanical parts

Introduction of mechanical parts

A discipline that studies and designs mechanical basic parts in various equipment, and is also a general term for parts and components. The specific content of mechanical parts as a discipline includes

08

2023

/

09

Key points of replacement of auto parts

Key points of replacement of auto parts

1., use sealant as much as possible. If necessary, paint can be used instead to achieve ideal sealing effect. 2. rubber seals should be carefully checked for appearance quality before assembly. Use special tools for press fitting to avoid knocking and deformation;

08

2023

/

09

What is communication network terminal equipment?

What is communication network terminal equipment?

The communication network terminal, that is, the computer display terminal, is the input and output device of the computer system. Computer display terminals are produced with the centralized processing mode of the host era, and continue to develop with the development of computing technology. So far, computing technology has experienced three development periods: the host era, the PC era and the network computing era. The terminal is adapted to the three stages of the development of computing technology, and the application has also experienced the three forms of character dumb terminal, graphic terminal and network terminal.

08

2023

/

09

Material description of valve body

Material description of valve body

1. gray cast iron gray cast iron valve with its low price, wide application and application in various fields of industry. They are usually used in the case of water, steam, oil and gas as the medium, and are widely used in chemical industry, printing and dyeing, oiling, textile and many other industrial products with little or no impact on iron pollution. Suitable for low pressure valves with working temperature between -15~200 ℃ and nominal pressure PN ≤ 1.6MPa.

08

2023

/

09

Process of mechanical parts

Process of mechanical parts

When designing mechanical parts, it should not only meet the requirements of use, that is, it should have the required working ability, but also meet the production requirements, otherwise it may not be manufactured, or it may be possible to manufacture but it is very uneconomical to cost labor and materials. Under specific production conditions, if the designed mechanical parts are easy to process and the processing cost is very low, such parts are called good manufacturability.

08

2023

/

09

< 12 >